NewPing sonar (TRIGGER_PIN, ECHO_PIN, MAX_DISTANCE) // NewPing setup of pins and maximum distance.In my opinion the schematic sucks! So I re did it. Here’s an example code: # include # define TRIGGER_PIN 9 # define ECHO_PIN 10 # define MAX_DISTANCE 400 // Maximum distance we want to measure (in centimeters). Using the NewPing library we can get the distance with just a single line of code. Then according to those results we calculated the distance based on it. In the previously explained code we manually triggered the sensor and measured the received signal pulse duration. There are actually a simpler and better way to program the Arduino to measure distance using the HC-SR04 ultrasonic sensor, and that’s using the NewPing library. void setup () Code language: Arduino ( arduino ) Example Code Using the NewPing Library In the setup we have to define the trigPin as an output and the echoPin as an Input and also start the serial communication for showing the results on the serial monitor.

Int distance Code language: Arduino ( arduino ) defines pins numbers const int trigPin = 9 Then we need a Long variable, named “duration” for the travel time that we will get from the sensor and an integer variable for the distance. In this case they are the pins number 9 and 10 on the Arduino Board and they are named trigPin and echoPin. } Code language: Arduino ( arduino ) Code Explanationįirst we have to define the Trig and Echo pins. Prints the distance on the Serial Monitor Serial. Reads the echoPin, returns the sound wave travel time in microseconds Sets the trigPin on HIGH state for 10 micro seconds digitalWrite(trigPin, HIGH) Clears the trigPin digitalWrite(trigPin, LOW)

begin( 9600) // Starts the serial communication PinMode(trigPin, OUTPUT) // Sets the trigPin as an Output pinMode(echoPin, INPUT) // Sets the echoPin as an Input Serial. */ // defines pins numbers const int trigPin = 9 Ultrasonic Sensor HC-SR04 and Arduino Tutorial Here’s a code for measuring distance using the HC-SR04 ultrasonic sensor and Arduino. As an Amazon Associate I earn from qualifying purchases. Breadboard and Jump Wires ……… Amazon / Banggood / AliExpressĭisclosure: These are affiliate links.Arduino Board …………………………… Amazon / Banggood / AliExpress.

Ultrasonic Sensor HC-SR04 ………… Amazon / Banggood / AliExpress.

You can get these components need for this tutorial from any of the sites below: The Ground and the VCC pins of the module needs to be connected to the Ground and the 5 volts pins on the Arduino Board respectively and the trig and echo pins to any Digital I/O pin on the Arduino Board.

Adding a raspberry pi in fritzing